440 bore kit..?

[Dustin075]

I have a 440 bore kit ready to be installed. I have a full pipe stage two cam and edelbrock carb. Is there any head work that needs to be done or any valve work before in install this beast? I do alot of trail riding. Any info on this would be great.

Thanks

[drew416ex]

for best results for you mods I would get the head ported, but its not needed. At the very least replace your valve seals and get the valves lapped to make sure they arnt warped and are still seating correctly.

[Grant Casey]

defentallly get a port job it will go hard then
\

[tdmopar59]

how much does a port job normally cost?

[XXXRACER165]

Anywhere from $250-$500.