PDA

View Full Version : Installing front sprocket


stumpleg
02-16-2008, 08:32 AM
I am getting ready to put on a primary drive front sprocket and just wondering which way it goes. On one side there is 13 and a clockwise arrow engraved. Is this the outside or inside. I assume it goes towards the outside. Also, which washers do I need to reuse when I put the bolt on. The one with the bolt hole, the bigger washer, or both.
bloodmoney23
02-16-2008, 10:42 AM
well, the lump side is the outside. the inside is either flat or has an indent around it.
INSIDE (MOTOR SIDE)
http://i32.tinypic.com/5cyv7t.jpg

OUTSIDE
http://i29.tinypic.com/2usza8g.jpg

Now when it comes to washers.....i dont nor did i have any on mine at any time.
Sjorge450R
02-16-2008, 10:47 AM
Originally posted by bloodmoney23
well, the lump side is the outside. the inside is either flat or has an indent around it.
INSIDE (MOTOR SIDE)
http://i32.tinypic.com/5cyv7t.jpg

OUTSIDE
http://i29.tinypic.com/2usza8g.jpg

Now when it comes to washers.....i dont nor did i have any on mine at any time.

hmmmm...for somereason i wanna say that you have that backwards. Its still early, so i am not fully sure...lol The rear is right, i am talking about the front.
bloodmoney23
02-16-2008, 11:10 AM
well im not worried about the rear one, i was just showing him which way the front goes on. I just changed mine 2 times and about to change it again cause i got my 18" tires in.
stumpleg
02-17-2008, 03:30 PM
Thats how i have the front one on. Went riding yesterday with it like that, everything seemed allright.
d3ktrix
02-17-2008, 03:54 PM
Originally posted by Sjorge300EX
hmmmm...for somereason i wanna say that you have that backwards. Its still early, so i am not fully sure...lol The rear is right, i am talking about the front.

He's got the front one correct.
The rear ones reversed.