Help Cam install

[tjar66]

Hey all I am in the middle of installing an HRC Cam and I am attempting to get the decopression bolt out and it is being a real bear. I can loosen it up about a turn and a half and it stops. I am assuming the bolt will come out the rest of the way but I dont want to crank on it if not. Any advice will be appreciated
Thanks Tim

[INFAMOUSRACER7]

try just a little heat beacuse they are loctited on but be careful and not use to much heat cause you can mess the little spring up on the release

[tjar66]

Yeah Thanks. It was the locktite holding it up. that is some good sh*t they use

[Sjorge450R]

i usually get a pair of vice grips and grab the cam with them were the sprocket bolts on. Someone holds the vice grips while i use the allen head tool that is in the tool kit to remove the decomp.

[INFAMOUSRACER7]

best way is to clamp where the sproket bolts in a vice and that way it doesnt slip and you dont have marks on your cam

[bloodmoney23]

Originally posted by INFAMOUSRACER7
best way is to clamp where the sproket bolts in a vice and that way it doesnt slip and you dont have marks on your cam

best advice, worked perfect with mine. and didnt mark anything up or even risk damaging anything.