PDA

View Full Version : FS:complete '86 trx250r engine



fourtrax250r
01-03-2008, 09:53 PM
i am selling the complete engine including electrical, and stock carb that is ready to run. i am selling the engine because i am going to put a cr500 motor in my frame. the motor has a newer top end and hot rods crank both with about 25 hours on them. it also has a newer standard output "ricky stator" stator. the clutch is a little worn and could probably use some new steels/fibers, but isnt too noticeable. it runs great and starts on 1st or 2nd kick. the only bad things about it are the chain must have come off and took out a small part of the case that has been fixed with JB weld by the previous owner and also another time the chain came off and took a piece off the case and i had it welded back on professionally, its good as new. it has never leaked in the 2-1/2 years i have had it. i replaced the kickstarter with one from a 250x that was laying around. its not really a problem though, it fits in the plastic, it just sticks out about 1/2" further because if the knuckle (i actually like it better, its more solid).


$650 OBO

http://img295.imageshack.us/img295/2259/img0329zq7.jpg

http://img299.imageshack.us/img299/9497/img0330lk9.jpg

http://img292.imageshack.us/img292/3640/img0331yj7.jpg

http://img176.imageshack.us/img176/5610/img0332gj8.jpg

littledirt929
01-04-2008, 11:01 PM
pm sent!