Hondamaster5505
12-31-2007, 06:46 PM
Hey guys, well its been a couple days since i installed my vapor, and im gonna install the temp sensor soon.
I have a couple questions about it in general though.
1. The vapor reads the temp from the top of the cylinder head, replacing the crush washer on the spark plug. What kind of temps should i be looking at when its installed? I wanna make sure i know when its overheating or not.
2. Will the wire melt? The spark plug is so deep down in the engine, that wont a cooling fin or just the heat in general melt the wire? Im kinda afraid of that...
3. Is it possible to adapt the temp sensor to the oil in the oil tank? or the oil cooler?
thanks
I have a couple questions about it in general though.
1. The vapor reads the temp from the top of the cylinder head, replacing the crush washer on the spark plug. What kind of temps should i be looking at when its installed? I wanna make sure i know when its overheating or not.
2. Will the wire melt? The spark plug is so deep down in the engine, that wont a cooling fin or just the heat in general melt the wire? Im kinda afraid of that...
3. Is it possible to adapt the temp sensor to the oil in the oil tank? or the oil cooler?
thanks