stever250r
12-29-2007, 11:38 AM
Here they are.
Could someone give me the measurement center hole to center hole for a 88 or 86 model rear dogbone? I know the 88 is longer than the 86 dogbone, and I need to know which one I have.
Also, I bought a used TCS rear shock and when I went to mount it on the upper frame mount, there was a small gap on both sides that allowed the shock to move left and right between the mount. Anyone have an idea why? The fiche for a stock shock does not show any spacers or shims? Im lost.
Next, Where is the best place to mount the rear shock resevoir, so that it does not get in the way of anything. Pictures might help.
And last, what rear fender brackets will be necessary to mount the rear fenders if I am using a aftermarket seat latch? It looks like I should only need the support bar, the two brackets that mount it, and the rubber stops that go on the end of the support bar. Is this correct?
Any help for the above would be appreciated.
Thanks
Could someone give me the measurement center hole to center hole for a 88 or 86 model rear dogbone? I know the 88 is longer than the 86 dogbone, and I need to know which one I have.
Also, I bought a used TCS rear shock and when I went to mount it on the upper frame mount, there was a small gap on both sides that allowed the shock to move left and right between the mount. Anyone have an idea why? The fiche for a stock shock does not show any spacers or shims? Im lost.
Next, Where is the best place to mount the rear shock resevoir, so that it does not get in the way of anything. Pictures might help.
And last, what rear fender brackets will be necessary to mount the rear fenders if I am using a aftermarket seat latch? It looks like I should only need the support bar, the two brackets that mount it, and the rubber stops that go on the end of the support bar. Is this correct?
Any help for the above would be appreciated.
Thanks