key relocation problem

[Napalm Nate]

I relocated my key switch after installing a trail tech endurance and now it wont start. I cut the four wires to the key relocated it then soldered them back together. Could I have ruined a relay or something? Any help or suggestions would be greatly appreciated.

you didn't need to cut the 4 wires...they go to the male end of a plug...is it possible that you soldered them to the wrong wires?

[Napalm Nate]

Figured out that they go to a plug after I cut them. The colors all match on the wires

did you check your fuse?

[Napalm Nate]

Where is the fuse located at?

[Napalm Nate]

found fuse. it was blown. thank you!

you are welcome...since the fuse was blown, it is possible that you wired something wrong..or you could have had them crossed while cutting and or soldering...if the fuse immediately blows again, you have something wired wrong