Pro Armor Kill Switch wiring??

[300ex_#387]

Well I bought a Pro Armor killswitch, and im not to familiar with the 450's wiring harness. I know I ground one of the wires, but where do I splice the other one? A picture would be great if someone could show me what wire to splice into. Thanks!

[keller45]

It's very controversial the way it should be done.
I just made something like you would get from Pro Armor to splice into the coil and ground it there. I would just buy the kit from them

[300ex_#387]

Originally posted by keller45
It's very controversial the way it should be done.
I just made something like you would get from Pro Armor to splice into the coil and ground it there. I would just buy the kit from them

I don't need the kit. It was like $11, for two ends that I can get for like 25 cents. I know I can wire it up, I just dont know what wire to splice into.

[stumpleg]

I grounded one wire to one of the fender mounts. Kind of scrapped some of the paint off before I did it. The other wire, I wrapped around the part of the coil that the bolt goes through.

[300ex_#387]

I got it figured out. I grounded one to a fender mount then wired the other one to a black wire with a white stripe. It was my killswitch wire that I had taped off from when I took off my box.