Honda10
12-04-2007, 03:03 PM
okay, i just installed my raptor rear shock on my 05 250ex, i noticed that it had a lot of play, so i put some washers on, yet it still had play.
I was wondering if i could take the the stock eyes oout of the 250ex rear shock and install them into the raptor rear shock so it will have a snugg.
Also one last question, correct me if i am wrong, adjusting the preload is the two rings at the top of the shock, right?
So i tried turning those since the shock is very stiff, and the only thing that did was twist the bolt hole at the top.
Please give advise
I was wondering if i could take the the stock eyes oout of the 250ex rear shock and install them into the raptor rear shock so it will have a snugg.
Also one last question, correct me if i am wrong, adjusting the preload is the two rings at the top of the shock, right?
So i tried turning those since the shock is very stiff, and the only thing that did was twist the bolt hole at the top.
Please give advise