How the heck does this engine come out?

[Flyin-Low]

Well, I've been working on the KVF700 I bought and I've got everything ready for the engine to come out.. And that's where the problem is. What's the easiest way to disconnect the front and rear driveshafts? Probably the same deal as any solid axle four wheel drive quad.

I'd post this in the correct section but they are dead as can be, and I need this info fast.

Thanks.


-Martin

[Flyin-Low]

So far:

[Honda_Matt]

Id imagine you'd have to pull the top ends off to remove the motor.

Sometimes its a pain to get motors in and out of frames.

[Flyin-Low]

Originally posted by Honda_Matt
Id imagine you'd have to pull the top ends off to remove the motor.

Sometimes its a pain to get motors in and out of frames.

No, that's not the problem. Once loose the engine will slide right out the side but I can't figure out how to disconnect the drive shafts easily.

-Martin

[rancherrider69]

youll prolly have to start from the front/back removing the differentials then the drive shafts then working towards the motor

[quad97]

See if your local dealer has a shop manual you can look at or buy.