mecheech
11-20-2007, 10:03 PM
Okay so I go to change out the roller weights, should be ez right, well I do remember Mom telling me we have Polish roots.
Anyway when I go to put the whole clutch cover back on I notice the kick starter and variator castle nut slots are not lining up and while trying to move them I unsprung the whole kick start assembly.
So I left out the whole assembly and put a bolt thru a rubber washer and steel washer setup on each side of the case. Does the kick start assembley hold any other parts in place? I am hoping I will be ok for racing(indoor MX) at least this weekend till I can get some time to put it all back together.
Also when I put it back together I see the post to catch the spring on the case and guess that the other end slips into the closest of the two hole in the large part after U give it about a 1/4 turn. On the little gear part there is a wire loop does that point up in the case or down?
Any help is greatly appreciated, just trying to make it to the race this weekend with an already too busy schedule with work and Thanksgiving.
Anyway when I go to put the whole clutch cover back on I notice the kick starter and variator castle nut slots are not lining up and while trying to move them I unsprung the whole kick start assembly.
So I left out the whole assembly and put a bolt thru a rubber washer and steel washer setup on each side of the case. Does the kick start assembley hold any other parts in place? I am hoping I will be ok for racing(indoor MX) at least this weekend till I can get some time to put it all back together.
Also when I put it back together I see the post to catch the spring on the case and guess that the other end slips into the closest of the two hole in the large part after U give it about a 1/4 turn. On the little gear part there is a wire loop does that point up in the case or down?
Any help is greatly appreciated, just trying to make it to the race this weekend with an already too busy schedule with work and Thanksgiving.