stroker motor

[Cole Trane]

I need to know what all you need to buy to stroke out your motor. Do you have to beef up the motor in anyway so it doesn't ruin your motor? You know, stuff like that. Also, how much can you displace your motor in cc's by doing this. Thanks.

[Cole Trane]

Thanks guys and gals for all the info on the stroker stuff. Real helpful.:confused:

[ridinthedunes]

You need a stroker crank. Other than that I'm not sure
what you "need" to have. I would think that if you were
just looking to get a crank you'd be better off with an
overbore, head work and maybe a cam, this way you don't
have to split the case. Hope this helps.

Be patient, sometimes you just have to wait till the right
person sees your thread who knows the answers and they
don't always get on every night.

R/T

You will need you crank stroked a rod a piston cylinder bored if you want to go big and a couple of other things shaved. These are the things you need to have done. You can go over 500cc if you want. Look in the other forums on stoker motors

1) Long Rod + Bearing
2) Piston
3) Spacer plate
4) 2 bottom Base Cylinder gaskets
5) Might wanna run a 1cc lower dome if you can (therefore mix gas)
6) After you take out cylinder might wanna hone it to be safe
7)

[Cole Trane]

Thanks all, I'm guessing that the best way to learn about this is to read. Thanks for the info. Later.:) :)

any time, you could call a local dealer or suttin to though they will give a better explanation