powder coat

[MOTORIDER68]

I dont know if this would work on a swingarm but I went to Walmart and bought some rhino liner in a spray can. This worked awesome on my nerfs and is holding up really good.

[hendershot106]

yaaaahhh it does work good-- until u spray wd 40 or a strong cleaner on them------ wd 40 will act as a thinner to it and the solvent will fade it very quickly--- i use it to touch up my blingstar textured grab bar and nerfs-- and if i didnt know it--- i cant tell any difference

[Drewltr450]

what about an axle how do you think that would that hold up ?

[hendershot106]

prolly not too well------ it would get rubbed off

[Drewltr450]

when you put it on the swingarm did u have skids on or did u just leave it and did it wear off at all

[MOTORIDER68]

I was replying to another post but I guess I hit new topic instead of reply...my bad

I have not put this on my swingarm only on my nerf bars. It is holding up well on my nerfs, very little have scratched off the bottom of them and I only did 2 coats. I think I would powdercoat my swingarm instead of this though.

[jherbie28]

send it to pappy, not expensive and well worth it:)

[Drewltr450]

i want to send it to pappy but im only 13 so i have limited money and i still owe a but load on my loan

[DEVINF450R]

I am thinking of powder coating my frame the bright orange/red that the suzuki S is on the stock 07 graphics, with my candy blue a-arms and swing arm... I am undecide on plastic.... it is either blue front /yellow rears, white carbon fiber (maier) front /blue rear

[MOTORIDER68]

That sounds awesome man!! Should look really cool