slow96hater
10-28-2007, 06:54 PM
i just got done putting my 406 top end back on my bike today, brand new. i also am useing a hc stage 1, that is also brand new. i figured id just pour the oil next to the cam, in like those two little cam pockets on both sides, but, how should i go about filling the motor with oil? should i just do it like you do a oil change, or should i drop some in the bottem end before i put my cam cover back on?
im just kinda leary about puting 3/4's of a quart in, and starting a brand new cylinder dry, the shutting it off and repeating till its full. i did use assembly oil, but will it last long enough to get the oiling system full, and not score the wrist pin or even worse, my cylinderwalls?
as far as break in goes also, im figureing on running the bike around a constant 1/4 throttle for about 20 minutes to break the cam in, but how should i go about the piston and cylinder?
thanks for the help everyone.
im just kinda leary about puting 3/4's of a quart in, and starting a brand new cylinder dry, the shutting it off and repeating till its full. i did use assembly oil, but will it last long enough to get the oiling system full, and not score the wrist pin or even worse, my cylinderwalls?
as far as break in goes also, im figureing on running the bike around a constant 1/4 throttle for about 20 minutes to break the cam in, but how should i go about the piston and cylinder?
thanks for the help everyone.