AC Propeg blackline nerf bars are so AWFUL

[nemored]

I Just got brand new ac blackline nerfs in silver with the removable propegs. I got them for my 86 trx250r and the part numbers check out. I cant even install them, they are off by over an inch in the front and are so deformed plus they didnt even come with all the mounting pieces. Im going to post pics shortly to show how off they are..Has anybody had any problems with AC before? I cannot believe these past inspection if there is even an inspection. Anyone have mounting issues with ac nerfs before?
http://img.inkfrog.com/pix/ebargaincell/003.jpg
http://img.inkfrog.com/pix/ebargaincell/010.jpg

[mineralgrey01gt]

i bought some used a/c propegs and they were off some but the bar that slides through the frame was bent a little bit so it was off some. I straightened it back out and it works fine

[GOTFEAR]

are you sure that they arnt 400ex nerfs

[mineralgrey01gt]

and whoever told you thats blackline nerf's shot you some BS lol

[coryatver]

ac has a reputation for not fitting well at all. also "blackline" nerfs are the nerfs that are powercoated black. Those are not powercoated black and are not blackline nerfs

[Live2Ride300]

I have that exact set on my 88' R. There were off by about an 1" I had to bend them into place. Absolutely horrible mounting.

They are the blackline nerfs, the Powdercoated black ones are the exact same as the ones you have there.

Might need to use some ratcheting tie downs to install them

:eek2:

[nemored]

"and whoever told you thats blackline nerf's shot you some BS lol"

"ac has a reputation for not fitting well at all. also "blackline" nerfs are the nerfs that are powercoated black. Those are not powercoated black and are not blackline nerfs"

they are blackline....... they have the removal pegs and it states on ac racings web site that they come in ALUMINUM FINISH as shown in the picture below

http://img.inkfrog.com/pix/ebargaincell/blackline.jpg

[mineralgrey01gt]

hmm well never even knew they came in aluminum finish or there was a difference between blackline and normal ones.

If the part #'s match just bend them some and force them on there. Then they will be a tight fit at least

For one, they are bent to hell and back, that left side one looks bent pretty bad

[gsxr68]

have a set and had to put a ratchet tie strap and pull it in mine are 3/4 to wide

[atvmxr]

those pegs looks like are nowhere close to being level. good luck hitting the rear brake :eek: