Question for you.....

[TWISTED]

I can get stuff pc'd at work, I just have to blast them myself. My question is, after I blast them, is there some kinda of chemical I can clean them with??? The last set of wheels I had done, the pc had bubbled up on the inside of the front wheels. The guy that did them said it was probably grease or brake fluid. Just looking for some pointers....

[Pappy]

blast them, and wash them with simple green. if they have a phosphate coating, apply it and rinse as well.

some rims have that rolled lip or with beadlocks the welds can trap grease or other junk that is hard to remove with blasting alone(you would think it would come off but it doesnt...lol)

ive even seen oil impregnate blasting media and cause the oil to get on other blasted parts....so its always good to check everything before begininng and to wash what you can. (this is why I try like crazy to get folks to clean parts before sending even though I reclean and blast everything, it just cuts down on issues)

[TWISTED]

Simple Green, huh??? Endless supply of that at my disposal.. Thanks...

[jherbie28]

share the welth:devil: good luck man