project400ex19
10-16-2007, 08:42 AM
I just ordered a 450R carb. and a jet kit. I will admit I am horrible at Jetting. Where should I start with Jetting? I have a CT full exhaust system, Uni Filter, Aluminum airbox without a lid. I am at about 1800 ft above sea level. temperatures range from 40 degrees to 90 degrees. mostly around 65 or 70 though.
I know I'm going to have to modify my intake boots, and that's no problem. I'm going to form my tank around the carb, by putting warm water in it and forming it with a spoon. Since I don't really care what happens to my stock tank.
Any tips or helpful hints would be great. Yes I know there is a sticky on this but Just wanted to hear if anything else has been discovered I should know about.
I know I'm going to have to modify my intake boots, and that's no problem. I'm going to form my tank around the carb, by putting warm water in it and forming it with a spoon. Since I don't really care what happens to my stock tank.
Any tips or helpful hints would be great. Yes I know there is a sticky on this but Just wanted to hear if anything else has been discovered I should know about.