Top end

[Scott-300ex]

Alright well I went to race sand drags last night, it was a lot of fun. First launch I stood it up, wheelied to the balance point dropped it and took off, then every run I just kept getting better, so it was neat.

There's a guy there that I'm budds with and he told me he heard piston slap, like piston going side to side and he said its time for a rebuild.

Now I was gonna do a top end in December no matter wut.

But I have a race, xc in 2 weeks and should I do it before that and haul *** and get it done or just wait till after? I figure I could pick up 3 tenths with a top end. I was dead even with a new CR250 modded, so I thought that was good since it was modded and half the wieght. And I was runnin faster than a Banshee there to

So now or in 2 weeks?

Piston, rings, head gasket, base gasket, hone. And where should I get the honing done? Honda shop or send it somewhere?

Thanks