kill switch install

[casey_lamm]

I just got a kill switch which is required by a local track. I didn't get any instuctions with it. There are 2 wires...one is for the ground. I can figure that much out. Where does the other one go?

[f150mann]

the other one goes to a wire from your coil.. i forget what wire i used. something tells me black with yellow? someone will know for sure.

[hungus07trx400]

Black with yellow, i just put mine on yesterday

[casey_lamm]

where is the easiest place to get at that black w/yellow?


Originally posted by hungus07trx400
Black with yellow, i just put mine on yesterday

[hungus07trx400]

for my 07 I lifted the hood above the light off and the module was under there, spliced open and found it. Then I sandwiched the ground from the kill switch under a nut right near it, and ran it back up to my bars

[casey_lamm]

installed and working fine... man they dont give you much slack on those wires...


Looks like im ready for the track tomorrow.

Thanks for the help.


Originally posted by hungus07trx400
for my 07 I lifted the hood above the light off and the module was under there, spliced open and found it. Then I sandwiched the ground from the kill switch under a nut right near it, and ran it back up to my bars