PDA

View Full Version : 250r Esr 330 Powervalve Motor Fresh Build!


DanW
09-06-2007, 02:21 PM
This motor has about 5 hours on a complete rebuild. I didn't skimp on anything when I built this. This is a very fast, solid, relaible, easy to ride motor, that is every bit as fast (or faster) than any current 4 stroke. This is what I put into the motor with approximate prices.

-ESR330 Powervalve top end and spacer plate - $1600.

-Hinson outer clutch basket - $225.

-New OEM HONDA crank/rod assembly - $300.

-New OEM case bearings - $150.

-New shift shaft, seals, gaskets - $75.

-Cases machined to make room for the good style 330 - $50.

This motor really has 5 hours (or less) on it! The 330 Powervalve cylinder is not ported. You can have your builder port it, or run it the way it is. Eddie Sanders cut me a custom head dome so that the compression is at 160 psi. I did this so that I could SAFELY run the crappy pump gas that we have today. Even with this low compression motor, this thing pulls almost like a 4 stroke in the trees, yet has more top end than most 4 strokes out in the open fields.

You could raise the compression, run race gas, and this motor would be faster than super fast... If you could hang on.

:D

$1600 shipped. As you can see, I spent much more than that building it. I need money for a new project though, so it's got to go!!!
DanW
09-07-2007, 05:53 PM
This motor will go on Ebay if it isn't sold by Tuesday.
DanW
09-08-2007, 08:20 AM
I would consider trading this motor for a 250cc mx bike.
havinnoj
09-08-2007, 12:24 PM
what all comes with the clutch basket setup? post some pics of the condition? 8 plate?
DanW
09-08-2007, 12:48 PM
Originally posted by havinnoj
what all comes with the clutch basket setup? post some pics of the condition? 8 plate?

The Hinson clutch basket is the outer basket. It is installed on the motor - only been used for 5 hours. It is basically new. The inner clutch hub is new OEM, still in the Honda bag.
DanW
09-08-2007, 12:50 PM
pic
DanW
09-08-2007, 12:51 PM
This motor will come with the oem kickstart lever, Nacs case saver, and 450R aluminum shifter.
tfuchs
09-08-2007, 02:49 PM
That motor flat out hauls a s s . I was wide open on my 06 R and he blew my doors off
DanW
09-10-2007, 08:46 PM
This motor will be going on ebay soon. Save me the hassle and make me an offer...
DanW
09-11-2007, 04:05 PM
No offers? Nobody likes ESR powervalve motors? Too much power?? :p
ZSNOW
09-11-2007, 06:28 PM
whats the new project ur doing? if u still have the motor maybe we can work something out for a trade depending on ur new project...:confused:
DanW
09-11-2007, 07:00 PM
New project is top secret... :D
DanW
09-12-2007, 03:37 PM
SOLD!