ZeiK
09-06-2007, 06:15 AM
I Have a 1994 Honda TRX300FW
Got it from my Dad he has repalced the Cdi, Stator, Coil, Battery, Spark Plug,Pulse Generator, & Rectifier
When you crank it with the start button it cranks with out a spark until you release the start button and then it fires once.
I have had a few people tell me they have heard of this problem but could not remember what fixed it
Have Taken cotinuity and resistance tests on stator and coil they look good Have checked the ign. switch and Engine stop switch they look good
Checked Diode according to manual should run positive on Meter to + side of Diode and Negative on meter to - side of diode with a reading and switch other way you should not get any reading I get the opposite results was wondering if my repair manual has a miss print or if there is any way this could be causing my problem?? Does not Say in manual what problem would occur from a bad diod. Back of Diode Reads - >| +
Also is it possible the pulse regulator is good but there is some reason it is not picking up the fire signal I am not sure exactly how it functions but when I test it with ohm meter for resistance between the blue/yellow and ground I get a good reading?
Any help is greatly appreciated
Got it from my Dad he has repalced the Cdi, Stator, Coil, Battery, Spark Plug,Pulse Generator, & Rectifier
When you crank it with the start button it cranks with out a spark until you release the start button and then it fires once.
I have had a few people tell me they have heard of this problem but could not remember what fixed it
Have Taken cotinuity and resistance tests on stator and coil they look good Have checked the ign. switch and Engine stop switch they look good
Checked Diode according to manual should run positive on Meter to + side of Diode and Negative on meter to - side of diode with a reading and switch other way you should not get any reading I get the opposite results was wondering if my repair manual has a miss print or if there is any way this could be causing my problem?? Does not Say in manual what problem would occur from a bad diod. Back of Diode Reads - >| +
Also is it possible the pulse regulator is good but there is some reason it is not picking up the fire signal I am not sure exactly how it functions but when I test it with ohm meter for resistance between the blue/yellow and ground I get a good reading?
Any help is greatly appreciated