handlebar bends

[FMFz400]

I want to buy new handlebars for a z400 but keeping the 7/8" width...what bend would equal stock? and i've seen that a lot of people are going with the cr high bend...what would that be like on the stock mounting clamps?

[honda8&3]

I do believe that Pro Taper SE bars are 7/8th's so it would fit your stock mounts. I just installed a set of pro taper contour bars that are 1 1/8" thick at the mounts and taper off to 7/8's on the bars hense the name Pro "Tapers". :p I'm not sure how the cr high bend is but my atv mid bend bars seem pretty close to stock set up.

[250rmike]

for me i had a set of tag atv bend bars and they were to high i would go with cr high but thats just me if you want something close to stock look up what the stock measurements are for the bars and get something close to that

[Scott S]

IMO the CR High on a stock stem will be too low. The ATV mid or high bend will be closer to stock.