need help. How to install tether kill switch

[400exrapes]

im a bad searcher i tried but is there a thread on how to install? or do i get instrcutions with a pro design kill switch? if theresnone i need help.

[xxnightraven73x]

well you should get instructions with it but here you go its a simple two wire hook up black goes to ground and the other wire hooks to the hot wire on the coil mines a white wire but yours could have a diff color once you connect the wires fire it up and give it a tug it should shut it off just the same as your kill switch

[400exrapes]

thanks i appreciate that if theres instructions in there then im sure i can figure it out, but if the directions are not clear i'll take your advice. thankyou

[MO-EX-RIDER]

if i can remember, its a green or black wire with a yellow or white stripe down the middle that runs to the plug in the cdi box.......tap into that and ground the other

[JOEX]

One wire goes here...

[JOEX]

The other goes here or another frame contact...

Make sure it's a good metal to metal contact, paint and powder coating will interfere with good contact.

[400exrapes]

thanks

[Jnblaster05]

thank you aswell i was just lookin for some pics of this