rotax cylinder????

[mxduner]

has anyone heard of or seen some rotax sled cylinder on a r bottom end? I seen a picture of one in a local newsletter.It has their powervalve in it.I thought it might be off of their 500 twin sled engine:confused:

[KYmxracer52]

If I'm not mistaken, back in the early to mid 90's, there was a 250R quad in DirtWheels that had a Rotax engine. Pretty sweet looking.

[jon370r]

How is this to wet your whistle? It runs a little on the warm side while I ride in the gravel pits and hill climbs so I’m in the process of putting a fan on my bike for when I need it. I have a Bridgeport milling machine and lathe to do my own machine work. I just need to buy a good welder to do the aluminum with and then I will be able to do all the work myself.

[mxduner]

dude that is sick!is there a thread on here with info on your setup?man i gotta know:eek:

[RichM1983]

Didnt you have that bike on ebay jon370r??

[racerx573]

http://saberracing.com

[jon370r]

Originally posted by RichM1983
Didnt you have that bike on ebay jon370r??

Not the bike, just the engine. I have engine cases and parts to build a couple more of these so I was looking to sell this one to finance the money needed to get the rest of the equipment I need to do it all myself this time. I know this combo runs very well and the next one I build will be another step up with porting done and higher compression.

[racerx573]

For Rotax-R kits..

www.packardracing.com is one of the best you can go to. He's been doing it for probly close to over 10 years.

[honda350r]

Here is one of the first one in the country

[honda350r]

This is the one I had K&T build I would not recomend building one!

[mxduner]

:eek:

[fastR]

Originally posted by racerx573
http://saberracing.com
ya i agree with that, a hell of a lot easier