Exhaust leak

[yernkie]

I have had an exhaust leak on my 400ex ever since I installed the full Yoshi system. It leaks a little bit where it bolts to the cylinder head. I have pulled it a few times to clean everything up, new exhaust seals/gaskets, and studs, but it still does it. Anyone else run into this? It isn't anything major, but it "ticks" and it drives me crazy!

[GOTFEAR]

yea all the time you need to run up the bolts even as posible if you kep having the problem try two gaskets.

[EX LONERIDER]

are you making sure the headers are not binding inside the flanges? make sure to set them in evenly, wiggle them in and tighten them little bit at a time. they should seal without too much of an issue.

if anything, look for the "dark" burnt spots. that will indicate where its leaking from. good luck.

[Hondamaster5505]

you might have to put gaskets it, it was doing that with my DMC in the same spot, so i just tightened harder and it went away. lol.