mak400ex
08-18-2007, 11:29 AM
Click on or cut and paste the below link.
http://www.exriders.com/vbb/showthread.php?s=&threadid=312750
I installed the following - Lonestar Anti-vibe Steering stem and clamp with Pro Taper SE - high handlebars. Here’s what I did on Relocating the Ignition switch, Neutral and Reverse lights. After you have your aftermarket bar installed, remove the Ignition switch, Neutral and Reverse lights from the stock cover, Remove the nose cover it just pops off, I mounted the Ignition switch, Neutral and Reverse lights on the front top sides of the left and right fenders - (SEE PICS FOR LOCATIONS) the Ignition switch is centered on the flat part of the top side of the fender mark it and then drill a 1” hole this hole will need to be notched just look at your Ignition switch barrel its about 1/16 notch. Push it thru the plastic fender until it snap into place then plug in the wiring. For the Neutral and Reverse lights remove the lens from both they just pop out - (SEE PICS FOR LOCATIONS) Neutral and Reverse lights are centered on the flat part of the top side of the fender mark it and then drill a 5/8” hole I put my rev light on the side with my rev switch and the neutral light on the side I mounted my ignition switch. With the lens out push thru the rubber part of the assembly thru the inside wall of the plastic put a little spit on the lens cover lip and push it in, now repeat this for the other side – just make sure when you are drilling the hole the you have clearance to mount these items – look a the pics closely that I have attached you will see it’s a tight fit but this set up looks clean and you have no problem seeing the lights. If you need more info and or give me some feedback just add a comment to this post.
http://www.exriders.com/vbb/showthread.php?s=&threadid=312750
I installed the following - Lonestar Anti-vibe Steering stem and clamp with Pro Taper SE - high handlebars. Here’s what I did on Relocating the Ignition switch, Neutral and Reverse lights. After you have your aftermarket bar installed, remove the Ignition switch, Neutral and Reverse lights from the stock cover, Remove the nose cover it just pops off, I mounted the Ignition switch, Neutral and Reverse lights on the front top sides of the left and right fenders - (SEE PICS FOR LOCATIONS) the Ignition switch is centered on the flat part of the top side of the fender mark it and then drill a 1” hole this hole will need to be notched just look at your Ignition switch barrel its about 1/16 notch. Push it thru the plastic fender until it snap into place then plug in the wiring. For the Neutral and Reverse lights remove the lens from both they just pop out - (SEE PICS FOR LOCATIONS) Neutral and Reverse lights are centered on the flat part of the top side of the fender mark it and then drill a 5/8” hole I put my rev light on the side with my rev switch and the neutral light on the side I mounted my ignition switch. With the lens out push thru the rubber part of the assembly thru the inside wall of the plastic put a little spit on the lens cover lip and push it in, now repeat this for the other side – just make sure when you are drilling the hole the you have clearance to mount these items – look a the pics closely that I have attached you will see it’s a tight fit but this set up looks clean and you have no problem seeing the lights. If you need more info and or give me some feedback just add a comment to this post.