G Force Axles

[250r4life]

Are they any good? my buddy bent his axle a week or two ago, and is looking to get a new one...

i dont have any experience with them, adn dont know how they compare... theyre consideralbly less expensive then some of the big names, and we're hoping its like primary drive sprockets- cheap but well made...

any input/feedback is appreciated...

[54warrior]

I have heard that they are pretty good for the $$$. Not sure about holding up on a MX track, but for the average rider, they are supposed to be pretty good.

[REDRIDDER]

also if you bend or crack a g force they will replace it or straighten it free a limited lifetime warranty.best part is like you guys said $199 bucks..

[Hotshoe18]

I have one on my z400 and it has held up great... biggest thing iv done with it is a 25 foot tabletop and it didint touch it. Its great for the money and its awesome to pop the wheels off, throw on a few spacers, and have a wider axel :). I keep mine set at +4 in.

[REDRIDDER]

Originally posted by Hotshoe18
I have one on my z400 and it has held up great... biggest thing iv done with it is a 25 foot tabletop and it didint touch it. Its great for the money and its awesome to pop the wheels off, throw on a few spacers, and have a wider axel :). I keep mine set at +4 in. would you post a pic of your z400 rear end?thanks

[Hotshoe18]

shure, i'll go out and see if i can snap a few

[tar]

I have one but I don't have much ride time but i have ridden at the dunes with it and thats usually where I bend stuff but its holding up great.

[Hotshoe18]

I took the picture but it says their too big. If you have an email i can send them to, just give it to me and i'll be happy to send them that way. if theres another way to post them on here, just let me know and i can do that too

[mx1791]

mines holding up fine for mx

[01 400EXer]

I have one on a 400EX and it is holding up great. It has taken the 60ft. table top at Breezewood with stride. At first I had problems with the hubs loosening, but I lubed them up with grease and have not had any problems since.

[TRFOXX]

I have one on my z400 also and so far its held up great dont have a lot of time on it so far but the 4 times that i have rode its been sweet. The first 2 times i rode, after each ride i had to tighten up the axle nut but the last 2 times its been staying tight.

[esr250r86]

My friend has been running one on his 04 400ex and it has held up pretty well considering the way he rides it on the track sometime. Its a pretty good axle for the price and rocky mountain is always good to do buisiness with and will guarrantee thier products from my past experience. I went with a laeger axle on my trx450r and it is awesome.

[skatrdude20]

My buddy had one on his Blaster. If you knew him, you`d know he beats the HELL out of his bikes. I think the axle is the only straight item on that bike these days. Their nice axles.