what to polish next?

[DGR Designs]

any suggestions on what i can polish next? the throttle cover and rezzy cover are already done.

[Sparks425Ex]

Take you Oil Filter Cover and Starter Cover off and polish them. All of your levers, Front Brake Lever and Clutch Lever. If you want to you can polish your Calipers but you have to disassemble them. You can also polish your Shock likage.

Your oil tanks can also be done. The bigger stuff takes some time.

[Sick0]

I did my entire motor, oil rezzie, levers, thumb throttle, handlebars, handle bar clamp, pipe, nerf bars, spindles, rear sproket and axle, engine mounts, And I'm think about the hubs but I think I'm just going to powder coat them. Oh I also polished my bumper and rims(reapplied). The first think I did was the oil cover, and motor mounts.

[luvmyex]

I just finished my oil rezzi.Damn my fingers are sore!I dont have any fingerprints on the tip of my first two fingers.I sanded em off!It took me about 10 hrs to do it.I was hopeing its was just a bad paint job but the tank it self was pretty rough.I also used mothers polish for the first time,man i like that stuff.Its much better that what i have been useing.Now i get to do my filter cover tommrow.

[Sick0]

Try polishing you side cases. Thats paint is tough to get rid of.

[redrider ex]

get you a bench grinder and buffing wheel i polished my oil tank head pipes oil filter cover starter cover motor mounts trottle cover master cylinder cover rear rotor hub and handle bars in about 2 hrs

[luvmyex]

That was using my hands,a drimal tool,and a sander.i dont see how you could to all that in two hrs and it look worth a crap.

[redrider ex]

but my camra is cheap and you can't see it that well

[redrider ex]

:D

[redrider ex]

:D

[redrider ex]

ok

[suck my pipe]

Pull the black ruber thing off of your throthle, it's not polished but you could polish it if you want but i like the just plane aluminum look my slef!!!!!:devil