Installing Dirt Bike Kill Button

[racerx573]

I am looking at installing a push button killswitch, in addition to my Pro Design on my YZ426, and was wondering if anyone else has one of these. That way I can keep my tether cord on it, and not have to pull it out every time I shut off the bike. I got the engine used, from a guy who already had the wiring for a Pro Design on it, so I just hooked it up to that. I went to install the new carb I got today, and noticed there were 3 cut wires there was a red, black, and white one I believe. Could these be the wires? I already have a bike kill button, and all it has is a hot wire and a ground. I know a few people who have installed the kill button for the same purpose.

[ss440ex]

The three wires that were cut ( I thought they were red-green-and black) are for the TPS,Throttle position sensor.

They will have nothing to do with a kill switch.

[Bills racing]

run it to one side of the kill switch. Mine works great

[iraq66]

just hook it up to your teather thats all i did. hoot it up dont tape it strat it. if it dont start switch the wires around try it then should start tape it up and your done