PDA

View Full Version : 400ex swingarm bearing install



Moded86R
07-28-2007, 07:07 PM
I am replacing the bearings where the pivot bolt for the swingarm goes through.I've removed the old bearings.

I'm not sure how far to install the new bearings into swingarm.It's kind of a press fit.The old bearing's where trashed and the chain side I couldn't even tell there was a bearing so I don't know how deep the old one's were.

Thanks for any help.

250x_kyle
07-28-2007, 11:46 PM
did you watch when you took them off. if so there is a little washer type thin that fits down in and kind of rides on it then the dust caps go over that. put the bearing in far enough that the washer thing slides in (i think they consider it a bushing) post a pick of your pivot bolt kit and ill circle the piece im talking abou tif i have to lol. i dont know how to explaine it