400ex or 450r Front Bumper on 250r??

[ny250r]

Wondering if a 400ex or 450r bumper would fit my 86 250r?? Right now I have a Duncan Racing bumper on it that has seen better days. Rocky Mountain ATV and Dennis Kirk both have a bumper that I am interested in but don't list that it fits the 250r. I'm looking into the DG GNCC and GNCC Type II. Also like the Roll Design Classic and Intimidator. I don't mind a little fab work to make one work. Thanks for any suggestions!!

[x.system]

Originally posted by ny250r
Wondering if a 400ex or 450r bumper would fit my 86 250r?? Right now I have a Duncan Racing bumper on it that has seen better days. Rocky Mountain ATV and Dennis Kirk both have a bumper that I am interested in but don't list that it fits the 250r. I'm looking into the DG GNCC and GNCC Type II. Also like the Roll Design Classic and Intimidator. I don't mind a little fab work to make one work. Thanks for any suggestions!!

Yes it will bolt on but the bottom mount is to wide so you will either have to add some type of spacers or bent the mounts in. I have a 400ex bumper on my R and I think it was about 1/2" to wide on each side at the lower mount. The upper mount is spaced the same as the R.

[wishmasstir]

this is the ac 450r blackline bumper, just add some spacers or washers to make it centered and your good to go. you might also have to oval out the holes to line them up

[pimpt250r]

the bottom mount is between.25 and .5 of an inch thinner so you just need some spacers my blingstar was for a 450r and i just add some fat washers and its perfect

[x.system]

BTW the 400/450R bumpers are also a direct bolt on to the zuk ltr450.