A good crank rebuilder?

[Aceman]

My engine seems to be making a knocking noise louder than normal. Noticed upon teardown that my stock crank has about .024 side clearance, the up and down play is a little harder to gauge though. I can grab the small end of the rod and move it side to side about an 1/8", I assume that this confirms there is too much clearance up and down? I'd like to stick with a short rod crank, so my only option seems to be a rebuild. I've read several Hot Rod's posts and come to the conclusion that I'm definitely NOT going that route. Following the advice of 86 Quad R's many posts, seems like a Pro-X rod is the ticket. I'm considering Crankworks, seems to be a reputable shop and the closest to Oregon. Any thoughts or recommendations?

[86 Quad R]

looks to be a good builder to me. i'd go with them unless you have somebody local to you that is capable of doing the build. :cool:

[GPracer2500]

Crankworks is local to me. Their reputation is second to none AFAIK.

[Aceman]

Sent it off to Crankworks today. 2 week turnaround, I can't wait.:)