the best bottom end torque exhaust

[homemadebrownie]

whats is the best bottom end torque exhaust for a 250ex
yosh-slip on
big gun- slip on
hmf- complete
whitebros(eseries)- slip on
curtis sparks-slip on
pro circuit- slip on

out of these pipes plz tell me which would be the best for bottom end torque..thanks

[honda300EXtreme]

id go with the hmf

[Caseys 300ex]

hmf

[WB450r]

i like my pro circuit t-4 on my 450r....it has excellent bottom end power as well as mid range power.....its also loud

[400exrider707]

HMF slip on for best bottom. If you want bottom end just go with a slip on, the stock headpipe flows well and keeps a lot of the bottom end you sometimes lose with a full system.

Check out the dyno section, there was a dyno run of a 400ex with an HMF slip on and it was impressive gains in the low end to say the least.

[Sparky_20]

how many times has this been brought up? search!

[Caseys 300ex]

Originally posted by Sparky_20
how many times has this been brought up? search!

Settle down tiger. Without people like him asking them questions the forums would be slowly dieing and its not like u have never asked a question similar to his.

[homemadebrownie]

so the best pipe for bottom end would be a slip on yoshi, pro circuit, or big gun??

[brandon86]

I do alot ground stunts and I love my Big Gun slip on. K&N and Big Gun slip on the rejet and you will have good low end. I also droped a tooth on my front sprocket.

[Rancher2005]

my hmf slip-on came....45 minutes later it was installed and jetted. Their baseline jetting was spot on for me. It has really good low end torque. I enjoy bottom end because it seems to pull so hard when snapping the throttle or under heavy load. I would recommend it and think it's the best bang for the buck if you look at other prices. The chart that mobile dyno posted in the dyno section sold me on it. especially in comparison to the wb full system

[Jgoad2]

Originally posted by Rancher2005
my hmf slip-on came....45 minutes later it was installed and jetted. Their baseline jetting was spot on for me. It has really good low end torque. I enjoy bottom end because it seems to pull so hard when snapping the throttle or under heavy load. I would recommend it and think it's the best bang for the buck if you look at other prices. The chart that mobile dyno posted in the dyno section sold me on it. especially in comparison to the wb full system

Awesome, im considering getting one. How much louder is it over stock? And im assuming by the way u were talking about it the gains were pretty noticeable?

[zje400ex]

i was very surprized with my HMF slip-on. it produced alot of bottom end. more than i thought. i thought i did wheelies easily before...now its almost with the tap of the gas!