havinnoj
07-15-2007, 02:18 PM
Running a LSR frame. ESR's CR ignition mount obviously doesn't fit around the 1" round tubing. Does anybody make one or is it a custom made one on my end?
LSR frame - stock steering stem. Bearings are completely in and seated. Stem seats properly. The problem is this...
The stem itself has a protruding notch/groove towards the top. On stock frames, this notch sits right below the stem clamp on the frame. On the LSR frame, it sits exactly 1" too high. The notch is in the middle of where the clamp needs to go - stem is chrome so I don't want to grind it.
I was under the impression that stock stems work on LSR frames - I think LSR even told me this...anybody else run into this problem or know what's wrong?
LSR frame - stock steering stem. Bearings are completely in and seated. Stem seats properly. The problem is this...
The stem itself has a protruding notch/groove towards the top. On stock frames, this notch sits right below the stem clamp on the frame. On the LSR frame, it sits exactly 1" too high. The notch is in the middle of where the clamp needs to go - stem is chrome so I don't want to grind it.
I was under the impression that stock stems work on LSR frames - I think LSR even told me this...anybody else run into this problem or know what's wrong?