master break cylinder!

[oleboy87]

when i bought the bike there was a screw striped out on the cover soo i cant get it off to add break fluid! any suggestions on how i can get that screw out?

[Sparky_20]

try a small punch and a hammer to make a notch in the screw head and turn it out that way.

[GOTFEAR]

try a torq bit get the one that almost fits in the screw head and hamer it in turn bad screw out works all the time.

[oleboy87]

yea im going to try that but idk b/c i think the screw is seized in there! but ill give it a shot!

[hontr35]

I had that happen to me also. But I was putting on a polished cover anyway so I just took a small grinder with a cutting disk on and cut a groove into the screw.

[REDRIDDER]

man its always one,but anyways what i did was pound a phillips head screw driver into the screw and put my weight at the top of the driver and twisted it while holding my weight to to.Also you can get a impact driver but their kind of a pain to use.