WTB 250r motor or bottom end

[JeremyKS]

Looking to buy complete 250r motor consider anything stock to big bore. Also looking for complete bottom end and or engine cases.

[JeremyKS]

ttt

[JeremyKS]

bump

[methyman]

I have a 330PV topend on my bike now. It has been resleeved and port matched. It was bought from ESR then reported by K&T Peformance. I put a new 4mm crank in my motor and put thee 330 PV topend on it. I did not report it to match with the 4mm. I just had the dome recut for the piston coming out of the hole .050. I considered putting stock cylinder on my 4mm stroker crank and sell this topend. If your interesed I will pull it off and sell it to you. I drag race a banshee and will be building a Saberrtooth for my next Honda motor so I really dont need it.

Matthew
methyextreme@hotmail.com