woods banshee

[02400exer]

lookin to set up a banshee for the woods wut kind of exhaust gearing and other mods would be needed

[400exrider989]

try bansheehq.com

[Mxjunkie]

Drop your front sprocket to a 13, dyno port 2 into 1 exhaust, 10mm reed spacers, vforce reeds, timing advance plate, probaly +3 or +4, air filter, skid plates, wheels and tires, nerfs and you should be set, make sure you spray all of the electrical connections with electrical grease so it wont shut off on you when you get it wet. :)

[bansheexcracer2]

buy mine. it is all set up for cross country racing. everthing is new. or I will sell all of my afftermarket parts too. pm me if you are interested in either.

[firefighterjosh]

I raced XC with these mods.

T6 Pipes
Adjustible timing plate
V force reeds
Pistons
Stock gearing
Razr tires
Shocks
Skids
+1 Stem
32:1 ratio oil


I really liked the set - up. Still had plenty for top end strait and still had low end I could lug around.

[Washburn]

This is my woods/GNCC Setup and I will have no problem with any beefed up 450. This is my Sig on the BansheeHQ

03 Blue Banshee
Holeshot XCRs up front Razr 2s 20x11x9 on rear
Chrome TR6s Will trade for Chrome PT Mids (PM Me for details)
Uni 2:1 Filter Modified airbox lid
Noss Head (Anodized Blue) 20cc Domes
Pingle Killswitch
Renthal Fatbars w/ Billit Clamps
V Force 3s
Pro Design Billit adj Timing Plate advanced 4 degerees
Billit Anodized Flame Gas Cap (ModQuad)
Billit Impeller (Mod Quad)
Billit Case Saver (Mod Quad)
Magnetic aluminum drain Plug (TM Design Works)
280 Mains everything else stock Elevation 1800ft above sea level

Just purchased
Elka Elites all around with Elka rear linkage on a Laegers -2 swingarm
+2+1 Lonestar Racing A Arms + Steel Braided Break Lines

Trinity 2:1 Intake with a single 35 PWK
Soon to come...
Scotts fully adjustable/rebuildable Steering Stem (First Mod after Suspension)
Razr 2s all around Rear Douglas Ultimate Beadlocks
Flexx Handlebars
Loadline Oversize Rad
IMS Kickup Footpegs (For $200.00 they better kick up and massage my leg)
Durablue Axle
Engine work this winter
Paul Turner Mids-Chrome
Buchanan Racing 4mil Longrod agressive woods port Job with 18cc domes and +7 Timing on VP110 GNARLY LOWEND WITH THAT BANSHEE HIT!

I have no problem hanging with any 4 stroke out there and Im not done yet my motors still stock with all of the major bolt ons