In need of some help

[Honda#4]

I just painted my bars and when I went to go put my clutch assembly on I striped one of the holes that the bolts go in to hold the clutch on the bars so my question is..

Can you get the bottom piece seperate or do I need to buy a whole new MSR clutch assembly?


I got a MSR AOF clutch perch and lever.

[EX LONERIDER]

if you just stripped it and the bolt aint stuck, find a tap and die set with the correct size thread and use the tap for the hole. clean of the bolt and run the bolt through the die.

should be fine there after just be real careful not to tighten it too tight or you'll cause the same senario all over.

[Honda#4]

I found a metric bolt that was longer that worked just fine. I did try the tap and die but that didnt work. Its all good though Thanks EX Lonerider for the help anyway.

[EX LONERIDER]

no sweat bud. good to hear you sorted it out.