Swingarm

[timmersam]

I am having a little trouble with my swingarm. I cant seem to it to slide into the frame. I grinded the powder coat off where it goes in and that didnt help. I installed a new All Balls bearing kit and it seems like the sleeve that the bolt goes in is sticking out to far just a little too far, but that wouldnt make sense. I was wondering if anyone knew a way to go about this without wrecking anything??
Thanks alot

[kiesta00]

If you still can't get it, take a grinder and grind a little off of the sleeve, can't hurt anything, don't go nuts on it though

[timmersam]

Thanks for the advice, I got it in with some towels and a sledge hammer. :muscle: