PDA

View Full Version : parking brake block off



stumpleg
06-12-2007, 09:38 AM
Does anyone know who makes a larger block off plate that will allow thicker rear brake pads to be put on? I have been having trouble getting Tusk or Streamline on with my Moose block off. The piston hits it before there is enough room to fit both rear pads on. Honda pads are just fine though, go figure. Thanks.

06-12-2007, 10:24 AM
Pull of the block off plate and cut off or grind down the rod sticking out of the caliper piston. that will allow you to press the piston in all the way. I did it to mine.

wykyd450R
06-12-2007, 01:48 PM
Only trim a weee lil off of the "post" that hits the block off. If ya cut too much off, as the pads wear, the post slides inward. If it slides in too much, it will drop thru.

GIXXER1KR
06-13-2007, 07:06 PM
I just left mine off till the pads wore a little and then put it back on!!!It will be fine i have ran my older quads with no block off plate and never had a problem.I thought about trimming the shaft but im all set!!!!;)