MX Banshee info needed.....

[trx440]

I'm looking for someone who has owned or who knows alot about Banshees set up for MX.

I'm talking about Laeger 250R geometry frame, Moto Fast 2 into 1 pipe, 2 into 1 carb set-up. The whole works.

Anybody know where to point me?

.

[PRBanshee]

The only mods done here are bills pipes, twin 34mm keihin carbs, milled head (to get 185 lbs of comp.) v-force reeds, and national port work done by PR Engines. They claim close to 100 hp at the crank. I am about 240 lbs and I upped the gearing F.15 and R.38 and this thing pulls so hard. It will do well over 100mph. All the engine mods trippled the bottom and doubled the mid ranges. It has alot more usable power without that hard and uncontrolable hit. very easy to ride.

[PRBanshee]

also you could go with that frame or you could just buy 2 + 2 A-Arms

[loboboy]

What do you want to know?
I have had a Stock Geo Lonestar Frame with Roll Design Suspension kits and I currently have Lonestar Outlaw Banshee with 250R Geo susp and PEP ZPS shocks.
The motor is a 7MM stroker with MX porting and 35MM carbs, I could go back to 30MM or 33's and have way more response off bottom but it then becomes too violent. I have not tried a single carb yet but I would never suggest running a 2into1 pipe. if you have any questions either ask them here or PM me.