ceofuller
06-08-2007, 10:37 AM
All i did was perform a maintenance program on my front calipers. Put them back togather, bled and tried to start quad for a test run.
esr intake
9 stage cdi
eddie carb
hot cams w/ported head
full trinity
i can see gas going into carb, it is wet
plug is clean and dry maybe not getting gas shouldn't the plug be wet? i pulled the plug cleaned and tested and i am getting a good spark.
put my hand over end of pipe to see if I was getting any compression. it will suck my hand up tight to the pipe and push it away with every stroke
any ideas fellas??
esr intake
9 stage cdi
eddie carb
hot cams w/ported head
full trinity
i can see gas going into carb, it is wet
plug is clean and dry maybe not getting gas shouldn't the plug be wet? i pulled the plug cleaned and tested and i am getting a good spark.
put my hand over end of pipe to see if I was getting any compression. it will suck my hand up tight to the pipe and push it away with every stroke
any ideas fellas??