400EX rear caliper slide pin dust boots

[HY400EX]

How do you replace the rear caliper slide pin dust boots?

[hontr35]

If I think what your talking about I just did this. Remove the pin from the caliper holder and pull it out. Pull both dust covers off. Put the inside one on first and then grease the pin, slide it into the hole and through the dust boot. Then put the outside one on and push the slide pin back through the outside boot. Have to be a little careful not to rip the boot. Just be sure you don't slide the pin to far out and pull it out of the inside boot. Hope this helps?