06 trx450er Drag bike! in MO

[Drag450R]

Some stuff has come up and could use some extra money!

Motor has been started but doesn't even have the break in ride on it. Switching the carb over to gas first!

06 Trx450er
Stock bore/stroke motor
new 06 crank, new crank bearings, seals, gaskets
new JE 13.5:1 piston
new hotcam stage 3 and new cam tower
head just fully ported, w/ +1mm in/ex valves (new valve guides and seals)
44mm lectron carb, setup for alky right now with packard oversive float bowl, will have gas needle and seat soon.
ESR airbox elim kit with K&N and outwears
new pressure plate, inner center, clutch mod
new cr500 clutch springs
new clutch cover
new dyna ignition (non-programmable)
new ron woods drag pipe
new moose clutch lever and clutch cable
new throttle cable
new starter
new coil and spark plug wire/boot
ESR temp gauge

MSR polished handle bars with custom key bracket
front marvin shaws comp shocks (16" eye to eye) only have a few rides on them
CRJ rear lowering kit (polished)
custom +6" swingarm, e-brake block off kit
braided rear brake line
newer regina chain
12 tooth front sprocket (have stock as well)
Noss case saver
stock rear sprocket
18x5 direct drive smooth buffs on douglas blue labels (have one weekend on them)
22x11x8 72" rollout 10 paddle haulers ultralites on douglas blue labels (only have 5-6 rides on them)
custom painted front plastics
have stock rears that are cut, but painted blue as of right now
05 rear grab bar (also have PRM rear grab bar for 06)
Front brakes have been removed (do not have all the front brake parts)
fan and overflow have been removed (come with bike)

HP tranny oil used in clutch side, GN4 in motor side for break in, Engine ice coolant.

Polished brake lever, polished shift lever and shift shaft, polished axle and tie rods,

I am looking to sell entire bike, not parting out as of now.
I want $7000 for it. I have a ton of money and time in it, no low ballers! 90% of this bike is brand new!

Thanks,
adam
http://i7.photobucket.com/albums/y262/Fordracing347/Picture035-1.jpg
http://i7.photobucket.com/albums/y262/Fordracing347/Picture043-1.jpg
http://i7.photobucket.com/albums/y262/Fordracing347/Picture038.jpg
http://i7.photobucket.com/albums/y262/Fordracing347/Picture041.jpg

[Drag450R]

New price $5000 need to sell ASAP

[Pred_003]

Free bump for one amazing quad!!!

[4LEAFCLOVER]

Would you be interested in a trade for an 1986 Honda 350R? I can send you some pics of it.

[Drag450R]

No sorry I need the money, going through a divorce!! No reasonable offer will be turned down!! This thing needs to go!

[4LEAFCLOVER]

I wish that bike was for sale about 3months ago before I bought this 250r. I had a 05 450R and sold it, BIGGEST MISTAKE EVER. Then I bought this 250R that was bored out with a 310R Trinity motor and tons of after market parts on it. Got it and the motor went out on me so I had ESR rebuild it with their ESR350 Powervalve engine. Now I'm trying to sell it or either trade it because I thought I was going to like the two stroke feel but I miss my 450R. I think I'm just use to that 4-stroke feel. If I can get rid of this thing I'm going to go back with a 4-stroke, preferably a built 450R. That's a nice quad you got there man. Whoever gets it is going to be a very lucky person. Sorry to hear about your divorce. I feel your pain. I just got thru going thru mine so I feel your pain. Take care man.

[Drag450R]

Right on well if you sell your bike and mine is still here and together then its all yours!! Good luck with your sale.

Ya the divorce sucks, I will build another one someday!

[TWISTED]

Just out of curiosity, have you ever run it on asphalt, and if so, what kinda times did you run???

[Drag450R]

No I have not, this motor has break in ride only on it. My buddy had an 04 similar build minus the plus size valves and he had a stage 2 cam. his bike went 4.9 in 300ft in sand! my bike should run that or a little faster!

[Drag450R]

if not sold by Monday I am going to part it out!!