View Full Version : Stock A arms
Blackguywithouta400
10-26-2001, 01:00 PM
Can the stock a arms be rebulit so someone could get them re powdercoated? im thinking about cuting off the old Tie rod ends and using some that are for aftermarket A arms. Are the bearings removable in the mounts if i do this?
"BLAHH"300!!
10-29-2001, 04:01 PM
why not go get some after market a-arms..- whats wrong with your stock ones-?? you can find some used ones on e-bay and maybe some in the classifides section...
what do you want to do with your stock ones again-??
ask you question over- i don't understand
Blackguywithouta400
10-29-2001, 04:20 PM
I want to remove my stock A arms and have them re powder coated since they are chipping. but it looks like the tie rod end isnt going to come out. Is the true?
You are correct,,,stocker Tie rods will not come out..now a good set of aftermarket arms will allow the tie rods to come out but they'll be powdercoated anyway if you buy em..
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.