twisted head off of bolt

[bigdman69oh]

twisted the head off of the bolt on the rear caliper that holds brakes in any suggestions:devil:

[gncc025]

try and drill it out. probly aint gone work but thats all i can think of at the moment.:confused:

[JW450R1]

is there anypart of the bolt sticking out of the caliper?.did u twist it off comming out or tightening it up.....

[honda6490]

At your local hardware store you can buy an extractor set, they work awesome if you do it right. You drill into the center of the bolt/screw/whatever you have, then put the extractor in and reverse it out. You usually need to drill a ways in for this to work, but if you drill it nice and centered in the bolt with a surgeons hand it should work awsome. I have done this 3 times in the past week haha. Hope this helps.

Zach

[bigdman69oh]

i broke it off taking it out it only turned about three times then stopped like i hit a brick wall the other bolt did the same thing
but did'nt break off so i tightened it back up and sead the hell
with it were do i get new brake studs if i get it out