Maier plastic problem

[2002Honda400ex]

How do I install the rear fender brace on my 400ex? The instrustions say to drill holes buy dont give a good pic or directions. If someone could post a pic it would hel alot

[<DRS>GPF]

not sure if its actually right, but heres my attempt..

[<DRS>GPF]

nuther pic..

[<DRS>GPF]

last one..

[miller821]

I never put mine on their, other then a lil wobbly seems to do good.

[2002Honda400ex]

Looks good to me. That is how ill do it then. ;)

[JPhonda]

ya it lookes eactly like how i did mine also.

[97WarriorRider]

ok..sorry for bringing this back..but instead of making a new thread I will use this and hope to get a response..How did you guys put the black rubber pieces in? I was thinking of heating them up just a little bit and pushing them in? also the maier holes seem to be alot smaller than stock. Thanks

[BlasterEaten250]

i just used a flathead screwdriver and pushed the tabs through. Took a little while but worked in the end.

[97WarriorRider]

yeah..sorry to waste anyones time that looked at this..I hadnt even tried to put them in yet and I wetn and looked at them and it was pretty easy..I dont like how you have to mount the bar though