Cernics start button HELP

[QIKLTR]

i just installed cernics start button and now my tether kill switch wont work. i have my tether wired to my rooll over kill switch box and it has always worked but now after installing the start button it wont work. i cant really understand how the problem would even be related. any suggestions would be greatly appreciated.

[CdaleXtreme]

On the Kill switch you purchased, you will find a wire that comes out of the plug, and then loops back into the plug. Wire your Kill switch into that, and ground the 3rd wire properly, and you will be good to go.

[Trx250rider86]

yup thats what i did, no problems yet other than my gunner kill switch being defective and dieing on me before a race, but cernics replaced my gunner with a Pingle that i have yet to put on,

thanks cernics!

[QIKLTR]

sweet thanks guys

[QIKLTR]

will that work with a pro armor kill switch or does it have to be a pingel...arent they different?

[Trx250rider86]

no its doesnt have to be a pingle, i dont know how the pro armor one is so i cant tell you, i would think they are all mostly the same

[hondaracer31]

I think the Pingle is "normally closed". The Pro Armor is "normally open".

[QIKLTR]

yeah thats what i was getting at honda...i gotta get it figured out i gotta make a 5 hr drive to my next race

[CdaleXtreme]

It must be a Normally Close Kill Switch.

[QIKLTR]

i got it figured out. it was the killswitch itself. made it to the race and finished 9th. 3hrs sleep plus 5hr drive and then 2hr race makes for a poor finish. i wont make that misstake again!