View Full Version : Shift Pin Relocator
WORCS 133
04-30-2007, 08:26 PM
Has anybody performed this surgery yet?
If so how do you get the 2 screws on the Bearing Retainer off?
I have tried everything, a screw driver, an impact, soaking it in WD-40 these suckers will not move:grr:
zuki1
05-01-2007, 05:05 AM
if your talking about the two screws that hold that little tab down, i used an impact driver, but don't hit it to hard or you could risk cracking the case, but this should definatly work just got to try at it a little bit.
foxman_23
05-01-2007, 08:54 AM
i ust used a screwdriver and hammer lightly tapping while turning. but an impact driver would have been better.
Tyler25
05-01-2007, 12:10 PM
I used a #3 phillips bit and a 1/4in ratchet and they came out no problem!
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.