PDA

View Full Version : How to install a prodesign kill switch



leoj12
04-29-2007, 02:47 PM
I would like to know how to install a pro design kill switch on the new KFX450r

rider250ex
04-29-2007, 09:00 PM
it would be alot easier to use a normally closed tether like a pingel so you can just wire it into the on off switch.

rpyfz450
05-25-2007, 12:15 PM
With a normally closed tether switch, if the switch goes bad because of a wreck or mud/water, the engine will run erradically or not at all. If a normally open switch fails, the engine is far less likley to stop running.

QUADROOKIE
05-25-2007, 02:27 PM
Originally posted by rpyfz450
With a normally closed tether switch, if the switch goes bad because of a wreck or mud/water, the engine will run erradically or not at all. If a normally open switch fails, the engine is far less likley to stop running.
I have never ever heard of a Pingle ever going bad though so I am not worried.;)